BW Technologies GasAlert Extreme User Manual download pdf (Page 56)

GasAlert Extreme

User Manual

Troubleshooting

If a problem occurs, refer to the solutions provided in Table 14. If the problem persists, contact BW Technologies by Honeywell.

Table 14. Troubleshooting Tips

Problem Possible Cause Solution

The detector does not activate. No battery Install a battery. Refer to Replacing the Bat-

tery or Sensor.

Depleted battery Replace the battery. Refer to Replacing the

Battery or Sensor.

Damaged or defective detector Contact BW Technologies by Honeywell

Reversed battery Reinstall the battery correctly.

The detector enters alarm mode immedi-

ately when it is activated.

Sensor needs to stabilize Used sensor: wait 60 seconds.

New sensor: wait 5 minutes.

Low battery alarm Replace the battery. Refer to Replacing the

Battery or Sensor.

Sensor alarm Replace the sensor. Refer to Replacing the

Battery or Sensor.

The start up self-test fails during one of the

checks.

General fault Contact BW Technologies by Honeywell

Alarm setpoints are incorrect Reset the alarm setpoints. Refer to Reset-

ting Gas Alarm Setpoints.

1 2 ... 51 52 53 54 55 56 57 58 59 60 61 62 63

No comments

BW Technologies GasAlert Extreme User Manual Page 56